Description

SR PRO 7 is recommended for coating over old rubber-based finishes or on smooth bare surfaces. Its attractive satin finish provides excellent chemical and immersion resistance while offering economical protection.

Coverage: 250-275 sq ft. per gallon.
*Minimum two coats on initial application.
**Not available in CA, PA, DE, NY, VA, MD, NJ and DC.

For more information on our Paint products click here. Back to Top

Features

Compatible with all chlorinated rubber or synthetic     rubber surfaces

Can be applied to bare surfaces or over old rubber      base coatings Back to Top

Installation

STEP 1:

Wash your Pool . From the SmartSeal Preparation Kit, use the trisodium phosphate compond mixed with water (8 oz per gallon of water cleans approximately 100 sq ft) Scrub vigoursly using long-handled stiff brush. Rinse about every 10 feet.

STEP 2:

Acid Etch Your Pool . This opens millions of tiny pores for the new paint to adhhere to and removes chalky residue or mineral deposits.

STEP 3:

Wash Your Pool Again. Washing again will help to neutralize any traces of acid. Use the same solution and technique from Step 1.

Note:

Your pool will be water saturated after cleaning. Always consult and follow label instructions. Back to Top